Chemical concentration measurement and control equipment

VOICE

I want to control the chemical substance concentration in the factory line on the order of ppm instead of%.

This has been achieved by using the titration method for measurement on the order of ppm, which was not possible with off-the-shelf sensor measurement methods.

Time-consuming titration work.The chemicals are collected from the factory and measured by laboratory personnel.I would like to collect data once an hour for process control, but it takes time, so I measure it once a day.I want to measure it frequently and manage it 24 hours a day.

This device fully automates complicated work from sample collection to pretreatment and concentration measurement. This aims at continuous process control and labor saving. Also, the result is saved on the memory card. You can check the measurement history on your computer.

Feature

• It enables continuous measurement on the order of ppm, which is comparable to manual analysis.
• From sampling and preprocessing to measurement, all complicated work can be done automatically.
• Time-consuming and labor-intensive titrations are fully automated.
• You can continuously manage various processes and save labor.
• The measurement results can be fed back to various processes.
•It is also possible to control the concentration.
• You can manage the measurement data on your computer.
• By combining with redox titration, neutralization titration, and METER series, it can be used for various measurement methods.

Iodine concentration automatic measuring device

(1) The “measurement liquid” is circulated by the “circulation pump”.
(2) 10 mL of the measurement liquid in the “sampling bath” is accurately supplied to the “titration tank” by the “sampling burette”.
(3) Dilute with “distilled water”.In addition, add “Chemical Solution 1” and “Chemical Solution 2” required for titration.
(4) The titration reagent is supplied by the “titration burette”.
(5) The end point is calculated from the relationship between the ORP potential and the dropping amount, and the result is calculated.The measurement result is displayed on the “touch panel”.
(6) The measurement result is fed back and the “concentration adjustment solution” is supplied.
(1)～(6)Repeat steps (1) to (6).

The above is an example of the system.We will design according to your specifications.

Product introduction

We will listen to your request and the process you want to realize, and by combining the products, we will provide the system that suits your purpose.